Specifications
Weight(grams): 1000
Dimension: 13 cm (Length) x 7 cm (Width) x 4 cm (Height)
MGAVCT - 1/4in Valve Core Removal Tool
Vacuum-Rated Valve Core Removal Tool for 1/4in Standard FittingsFitting Size: 1/4in Female flare to 1/4in Male flare
Valve cores effect refrigerant recovery and system evacuation times significantly. Always remove valve cores from the system for Full Flow.
Features and Benefits
Vacuum-Rated to 20 microns
Full Flow for high speed recovery and evacuation
Double O-Ring ball valve seal for accurate "blank off" vacuum testing
1/4" side port for service gauges
Designed for high pressure refrigerants including R410a
Magnetic Base - Never lose a stem again
Adjustable Tip - Grab all cores with confidence
Why Remove Valve Cores?
Valve cores are designed to restrict flow and minimize refrigerant loss. Up to 90% of the access port can be restricted by a valve core. Removing them maximizes flow and can save hours on any job.
Hot Tanks and Slow Recovery?
A valve core acts like an expansion valve, turning liquid refrigerant into vapor and superheating the refrigerant. This causes the tank to heat up and leads to painfully slow recovery times.
Tired of Slow Evacuations?
Evacuating through a valve core and core depressor can reduce the potential flow of any vacuum pump to as little as 0.2CFM.
Are your Tools Rated for Vacuum and Pressure?
All Appion Valve Core Removal Tools are Vacuum-Rated to 20 microns and designed for high pressure refrigerants, such as R410A. This will give you the peace of mind that your tools aren't going to leak in a deep vacuum or during critical parts of the recovery process.
VCT VCR Brochure 04062020.pdf
1.62 MB
TB Knurled Fittings.pdf
1.42 MB
Valve Core Tool Use and Care Sheet.pdf
567.27 KB
Inquiry - APPION MEGAFLOW CORE REMOVER FOR R22